Search
Now showing items 1-10 of 17
Thermal Performance of Integrated Plate Heat Pipe With a Heat Spreader
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The air flow rate available for cooling of notebook computers is very limited. Thus, notebook computer manufacturers desire a “passive” cooling method. Heat pipes are typically used to transport ...
Effect of GCL Properties on Shrinkage When Subjected to Wet-Dry Cycles
Publisher: American Society of Civil Engineers
Abstract: The potential shrinkage of eight different geosynthetic clay liners (GCLs) subjected to wetting and drying cycles is examined. It is shown that the initial (e.g, off-the-roll) moisture content may affect the initial shrinkage ...
Water-Retention Behavior of Geosynthetic Clay Liners
Publisher: American Society of Civil Engineers
Abstract: The hydration and subsequent hydraulic performance of geosynthetic clay liners (GCLs) depend on the water-retention curve (WRC) of the GCL. Because of the inherent difficulty in obtaining the WRC for these materials, limited ...
The Effect of Nuclei on the Inception of Bubble and Sheet Cavitation on Axisymmetric Bodies
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Hydrogen bubbles were generated as cavitation nuclei and their distributions were measured. The number and size distribution of bubble cavities generated on axisymmetric bodies was calculated and ...
Discussion of “Accuracy of Digital Image Correlation for Measuring Deformations in Transparent Media” by Samer Sadek, Magued G. Iskander, and Jinyuan Liu
Publisher: American Society of Civil Engineers
Optimum Accuracy of Two-Dimensional Strain Measurements Using Digital Image Correlation
Publisher: American Society of Civil Engineers
Abstract: ). The principle of the 2D DIC technique and its historical development will be introduced. Then, three potential techniques for taking strain measurements will be presented and compared: single readings, averaged linear readings, and an approach on the basis...
Curvature Monitoring of Beams Using Digital Image Correlation
Publisher: American Society of Civil Engineers
Abstract: A method for measuring longitudinal strains with the height at a section, and thus the curvature, using a technique based on digital image correlation (DIC), is presented. The background to this technique is introduced as ...
Reductions in GCL Overlap Beneath an Exposed Geomembrane
Publisher: American Society of Civil Engineers
Abstract: Reductions in geosynthetic clay liner (GCL) panel overlap are reported for two needle-punched and thermally treated GCLs (GCL1 and GCL2) and compared with values for two other needle-punched but not thermally treated GCLs ...
Development of a Combustor Liner Composed of Ceramic Matrix Composite (CMC)
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The Research Institute of Advanced Materials Gas-Generator (AMG), which is a joint effort by the Japan Key Technology Center and 14 firms in Japan, has, since fiscal year 1992, been conducting ...
Thermal Expansion and Contraction of Geomembrane Liners Subjected to Solar Exposure and Backfilling
Publisher: American Society of Civil Engineers
Abstract: Geomembranes (GMBs) are widely used as advective barriers in landfill liner systems. When exposed to the sun, GMBs exhibit a network of wrinkles as a result of thermal expansion. These wrinkles disrupt the intimate contact ...
CSV
RIS