Abstract: The linearized problem of an infinite steady flow about a thin cambered hydrofoil with a jet flap is solved. The flow is assumed to be inviscid and incompressible and the cavitation number ...

Abstract: A theoretical analysis is carried out for the steady cavity flow about thin hydrofoil sections at small incidence α, at the trailing edge of which a thin jet emerges at a small deflection ...

Abstract: The interpretation of model precipitation output (e.g., as a gridpoint estimate versus as an areal mean) has a large impact on the evaluation and comparison of simulated daily extreme rainfall indices from climate models. ...

Abstract: Cloud fields and concurrent dynamical structures associated with extratropical cyclones in a general circulation model are investigated with emphasis on the cool season (October?March). An ensemble approach is used for ...

Abstract: This work presents electromigration reliability and patterns of Sn–3Ag–0.5Cu and Sn–3Ag–1.5Cu∕Sn–3Ag–0.5Cu composite flip-chip solder joints with Ti∕Ni(V)∕Cu under bump metallurgy (UBM), bonded on ...

Abstract: In this paper the critical combinations of uniform pressures and concentrated loads at the apex acting on shallow spherical shells have been determined analytically and experimentally. The ...

Abstract: The effect of head-disk impacts due to repeated dynamic load is investigated experimentally. Loading conditions more severe than those typically found in ramp-load disk drives are applied to ...

Abstract: This paper investigates the reduction of vibration due to the foundation slab both in horizontal and vertical directions. Similar reduction efficiency of the foundation slab was obtained among three-dimensional finite ...

Abstract: The dynamic load head-disk contact induced impact stress was studied. A dual channel LDV was used to measure the head-disk relative motion during impact, and an analytical model incorporating ...