Search
CSV
RISExperimental Studies on Active Vibration Control of a Beam Using Hybrid Active∕Passive Constrained Layer Damping Treatments
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Hybrid damping designs with active piezoelectric materials and passive viscoelastic materials (VEMs) combine the advantages of both active and passive constrained layer damping treatments. In this ...
Incorporation of Friction Coefficient in the Design Equations for Elevated Temperature Tanks
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Storage tanks operating at elevated temperatures (200 آ°F to 500 آ°F) need to consider stresses due to thermal expansions and restraints, due to the tank shell and bottom plate interactions and operating conditions in ...
Fatigue Stress Evaluation at Shell to Bottom Joint With Double Plastic Hinge in Elevated Temperature Steel Tanks on Concrete Ring Walls
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The shelltobottom joint of hydrocarbon storage tanks is a critical location which may experience fatigue cracking and requires evaluation of the local cyclic stresses especially in the case of elevated temperature tanks. ...
Discussion of “<i>Behavior of Single‐Angle‐Compression Members</i>” by M. Elgaaly, H. Dagher, and W. Davids (December, 1991, Vol. 117, No. 12)
Publisher: American Society of Civil Engineers
An Efficient Three Dimensional FNPF Numerical Wave Tank for Large Scale Wave Basin Experiment Simulation
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This paper presents a parallel implementation and validation of an accurate and efficient threedimensional computational model (3D numerical wave tank), based on fully nonlinear potential flow (FNPF) theory, and its extension ...
Flexural Buckling of Steel Angles: Experimental Investigation
Publisher: American Society of Civil Engineers
Abstract: Structural steel angles have a wide variety of applications. However, steel angles have not received the attention comparable to heavy shapes such as wide flange sections. For steel angles, flexural buckling strength is ...
Development of Column Curve for Steel Angles
Publisher: American Society of Civil Engineers
Abstract: Structural steel angles have a wide range of applications requiring a comprehensive design methodology. One of the most important aspects of steel-angle design is the flexural buckling strength. In this paper, the test ...
The Shear Layer above and in Urban Canopies
Publisher: American Meteorological Society
Abstract: The nature and role of the shear layer, which occurs at the level of the average building height in urban canopies, are poorly understood. Velocity data are analyzed to determine the characteristics of the shear layer of ...
Search for Initial Conditions for Sustained Hopping of Passive Springy-Leg Offset-Mass Hopping Robot
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A springy-leg, offset-mass or SLOM hopper configuration is considered here, wherein the center of gravity of the body is offset from the line of action of spring force. It is observed that ...
Schifflerized Angle Struts
Publisher: American Society of Civil Engineers
Abstract: Schifflerized angles (90° hot‐rolled equal leg angles bent to 60°) are employed as main leg members in triangular‐base latticed communication structures. The strength of these angles is quite different from that of regular ...