Abstract: Systematic experiments were conducted on carburized 4320 steel to study thermalinduced transformation of austenite to bainite by measuring the volumetric transformation strains. Up to about 210°C, ...

Abstract: Cone bore growth in case-carburized bearings was modeled by incorporating the mechanisms of thermal-induced phase transformation and low temperature creep in an approximate model of the cone. The ...

Abstract: A finite element analysis is used to model cone bore growth in a railroad bearing. Factors which influence the growth and profile of the cone include (a) the initial interference fit between ...

Abstract: Fatigue life modeling of anisotropic materials such as directionally-solidified (DS) and single-crystal Ni-base superalloys is often complicated by the presence of notches coupled with dwells at ...

Abstract: The time- and temperature-dependent deformation behavior of two Sn-Ag base alloys, 96Sn-4Ag and Castin (96.2Sn-2.5Ag-0.8Cu-0.5Sb), used as solder interconnect materials was determined over strain ...

Abstract: The role of microstructure is quite significant in fretting because the scale of plastic strain localization near the surface is on the order of key microstructure features. A dual-phase Ti-6Al-4V ...

Abstract: The deformation behavior of two commercial lead-free solder alloys, Indalloy 227 (77.2Sn-20.0In-2.8Ag) and Castin alloy (96.2Sn-2.5Ag-0.8Cu-0.5Sb), over a range of strain rates (10−6 s−1 to 10−2 ...

Abstract: A continuum crystal plasticity model is used to simulate the material behavior of a directionally solidified Ni-base superalloy, DS GTD-111, in the longitudinal and transverse orientations. ...