Show simple item record

dc.contributor.authorA. K. Mathur
dc.contributor.authorP. A. Molian
dc.date.accessioned2017-05-08T23:20:23Z
dc.date.available2017-05-08T23:20:23Z
dc.date.copyrightJuly, 1985
dc.date.issued1985
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26906#200_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/99927
dc.description.abstractA 1.2 kw CO2 -CW laser operating in ring and Gaussian beam modes was used to surface harden gray and ductile cast irons. The microstructure, case depth, hardness, surface integrity, and distortion were studied as functions of process variables (i.e., laser power, focusing optics, beam size, scan rate and thickness of the specimen). The results indicate that the ring mode is preferred over Gaussian whereas ductile iron response to laser heat treatment is better than gray iron. The maximum case depth achieved with minimum melting was 0.38 mm, and the maximum coverage rate obtained was 322.58 mm2 /s.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleLaser Heat Treatment of Cast Irons—Optimization of Process Variables: Part I
dc.typeJournal Paper
dc.journal.volume107
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225802
dc.journal.fristpage200
dc.journal.lastpage207
dc.identifier.eissn1528-8889
dc.keywordsLasers
dc.keywordsIrons (Textile pressing)
dc.keywordsHeat treating (Metalworking)
dc.keywordsOptimization
dc.keywordsFunctions
dc.keywordsThickness
dc.keywordsOptics
dc.keywordsMelting
dc.keywordsNodular iron AND Gray iron
dc.treeJournal of Engineering Materials and Technology:;1985:;volume( 107 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record