• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Low Cycle Fatigue Crack Growth Behavior at Elevated Temperature Under the Combined Strain-Wave-Shape Cycling in Type 304 Stainless Steel

    Thumbnail
    View/Open
    JEMTA8-26907#346_1.pdf (1.402Mb)
    Date
    1985
    Author
    M. Okazaki
    T. Koizumi
    I. Hattori
    T. Ikeda
    Metadata
    Show full item record
    Abstract
    The low-cycle fatigue crack growth behavior of Type 304 stainless steel, when the slow-fast type strain cycles were introduced into the repeat of fast-fast type strain cycle either in a periodical type (denoted as Type-I sequence) or in a block type (denoted as Type-II sequence), was investigated at the temperature of 873 K. It was found that an inertia accelerating phenomenon of crack growth rate occurred during the repeat of fast-fast type strain cycle, which followed the slow-fast type strain cycles introduced. It was also found that the above inertia accelerating phenomenon led to the significantly shorter fatigue crack propagation life than that evaluated from the linear damage summation rule, especially in the Type-I sequence. The observations of the longitudinal section through the specimen and the distribution of Vickers hardness suggested that a creep affected zone would be produced at the crack tip by the introduction of slow-fast type strain cycles, and it would cause the inertia acceleration of crack growth rate. In this work, the creep affected zone size, Rc was defined by the size of the region where the inertia acceleration of crack growth rate occurred. There was a linear relationship between Rc thus defined and the range of creep J-integral, which was produced just when the introduction of slow-fast type strain cycles was finished. Furthermore, based on the results thus obtained, the predicting method of crack growth rates both in the Type-I sequence and in the Type-II sequence was discussed.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/99919
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV