Show simple item record

dc.contributor.authorK. Gabriel
dc.date.accessioned2017-05-08T23:20:00Z
dc.date.available2017-05-08T23:20:00Z
dc.date.copyrightMarch, 1985
dc.date.issued1985
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26403#107_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/99713
dc.description.abstractSpiral ropes of high load-bearing capacity are usually made of cold-drawn steel wires of high tensile strength. This material has been investigated by many researchers, not only to determine the mechanical properties of cold-drawn wires, but also to find out more about their stress-strain behavior under tensile loading and local three-dimensional stresses. It is now possible to determine load ranges for fatigue as a function of: surface conditions of the wire; the length of the wire; the diameter of the wire; local stresses resulting from damage to the wire surface; local stresses resulting from transverse pressure at points of contact where wires cross; friction between the wires produced by changes in stress; friction between the wires produced by changes in cable curvature; friction between wires and fittings or anchorage structures. Cables can be protected from corrosion due to environmental influences. If this is done the fatigue behavior of a twisted cable primarily depends on the addition of friction energy given to the material where strong contact forces cause three-dimensional stresses. A method of determining the fatigue strength of tension members made of cold-drawn wires is described using statistical methods, results of fatigue tests on short specimens, and precision measurements of the cold-drawn wire. It is possible to reach the material dependent fatigue limit of about 300 N/mm2 with a spiral rope by a welldone structural design and corrosion protection.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleOn the Fatigue Strength of Wires in Spiral Ropes
dc.typeJournal Paper
dc.journal.volume107
dc.journal.issue1
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.3231147
dc.journal.fristpage107
dc.journal.lastpage112
dc.identifier.eissn1528-8994
dc.keywordsWire
dc.keywordsRopes
dc.keywordsFatigue strength
dc.keywordsStress
dc.keywordsFriction
dc.keywordsCables
dc.keywordsCorrosion
dc.keywordsFatigue
dc.keywordsFatigue testing
dc.keywordsFittings
dc.keywordsAccuracy
dc.keywordsMechanical properties
dc.keywordsLoad bearing capacity
dc.keywordsTensile strength
dc.keywordsTension
dc.keywordsFatigue limit
dc.keywordsForce
dc.keywordsPressure
dc.keywordsSteel
dc.keywordsMeasurement AND Structural design
dc.treeJournal of Energy Resources Technology:;1985:;volume( 107 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record