Show simple item record

dc.contributor.authorC. S. Albro
dc.contributor.authorF. Liu
dc.date.accessioned2017-05-08T23:19:59Z
dc.date.available2017-05-08T23:19:59Z
dc.date.copyrightMarch, 1985
dc.date.issued1985
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26403#103_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/99711
dc.description.abstractThis paper discusses the effects of sheave groove shape, sheave diameter, and line tension on the frictional hold of polyester rope. A series of tests were conducted using five different sheaves, 5 and 9.2-cm-dia 2-in-1 polyester rope, under both wet and dry conditions. The frictional hold was determined from the difference in rope tension on opposite sides of a rotating sheave. The maximum tension on the high side was 245 kN. It was found that the coefficient of friction between polyester rope and smooth steel sheaves decreases with increase in rope tension for a given rope size. The 70-deg-V groove sheave shape demonstrated approximately 25 percent more frictional hold than the U-groove sheave shape. Holding capacity increases with sheave diameter. Large relative velocity exists between elastic lift line and sheave surface. Data will be used in a traction winch design.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffect of Groove Shape on the Frictional Hold of a Sheave on Polyester Rope
dc.typeJournal Paper
dc.journal.volume107
dc.journal.issue1
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.3231146
dc.journal.fristpage103
dc.journal.lastpage106
dc.identifier.eissn1528-8994
dc.keywordsPolyester fabrics
dc.keywordsPulleys
dc.keywordsRopes
dc.keywordsShapes
dc.keywordsTension
dc.keywordsTraction
dc.keywordsKnudsen number
dc.keywordsDesign
dc.keywordsFriction AND Steel
dc.treeJournal of Energy Resources Technology:;1985:;volume( 107 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record