Show simple item record

dc.contributor.authorJ. B. Johnson
dc.date.accessioned2017-05-08T23:19:52Z
dc.date.available2017-05-08T23:19:52Z
dc.date.copyrightDecember, 1985
dc.date.issued1985
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26408#506_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/99644
dc.description.abstractAn elongated, uniaxial brass ice stress sensor has been developed by the University of Alaska and used in several field experiments. Laboratory calibration tests have been conducted, in a 60 × 29.5 × 8.5 in. (1524 × 750 × 216 mm) ice block into which the sensor was frozen, to determine the sensor’s response characteristics. Test results indicate that the sensor acts as a stress concentrator with a stress concentration factor of 2.4 and transverse sensitivity of −1.3 at stresses below 30 lbf/in2 (207 kPa). At stresses greater than 30 lbf/in2 (207 kPa) the stress concentration factor increased and the sensor exhibited a time delay response to load. Differences of 22 percent were measured between the measured sensor stress immediately after a constant ice load was applied and the asymptotic stress limit. Interpretation of measured sensor stresses can be considered reliable at ambient ice stress levels below 30 lbf/in2 (207 kPa).
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleIn-Ice Calibration Tests for an Elongated, Uniaxial Brass Ice Stress Sensor
dc.typeJournal Paper
dc.journal.volume107
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.3231226
dc.journal.fristpage506
dc.journal.lastpage510
dc.identifier.eissn1528-8994
dc.keywordsBrass (Metal)
dc.keywordsSensors
dc.keywordsStress
dc.keywordsIce
dc.keywordsCalibration
dc.keywordsStress concentration AND Delays
dc.treeJournal of Energy Resources Technology:;1985:;volume( 107 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record