Show simple item record

dc.contributor.authorD. A. Hale
dc.contributor.authorJ. D. Heald
dc.contributor.authorS. R. Sharma
dc.date.accessioned2017-05-08T23:18:40Z
dc.date.available2017-05-08T23:18:40Z
dc.date.copyrightFebruary, 1984
dc.date.issued1984
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28231#37_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/98908
dc.description.abstractDynamic tests were conducted involving notched sections of 4-in. (10-cm) stainless steel and Inconel-600 pipe. The specimen was a four-point bending beam with end masses sized to give an elastic first-mode frequency near that of typical field-installed piping systems (15 Hz). Specimens were loaded using sinewave excitation at this first mode natural frequency. Specimen response was compared to predictions from an elastic-plastic dynamic analysis previously developed on this program. In addition, specimen loads at failure were compared to those predicted from a net section collapse failure criterion. The results confirmed that the elastic-plastic dynamic analysis adequately predicted the dynamic response of flawed pipes under seismic-type excitation. Furthermore, net section collapse does not occur under dynamic loading conditions which simulate natural frequencies of as-installed light water reactor piping systems. Finally, a net section collapse criterion yields conservative estimates of the load capacity of flawed pipe sections provided crack growth is properly accounted for.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDynamic Tests of Cracked Pipe Components
dc.typeJournal Paper
dc.journal.volume106
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264307
dc.journal.fristpage37
dc.journal.lastpage46
dc.identifier.eissn1528-8978
dc.keywordsDynamic testing (Engineering)
dc.keywordsPipes
dc.keywordsCollapse
dc.keywordsFailure
dc.keywordsStress
dc.keywordsPiping systems
dc.keywordsDynamic analysis
dc.keywordsStainless steel
dc.keywordsLight water reactors
dc.keywordsDynamic testing (Materials)
dc.keywordsFracture (Materials)
dc.keywordsFrequency AND Dynamic response
dc.treeJournal of Pressure Vessel Technology:;1984:;volume( 106 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record