Show simple item record

dc.contributor.authorR. M. Horn
dc.contributor.authorJ. N. Kass
dc.contributor.authorS. Ranganath
dc.date.accessioned2017-05-08T23:18:39Z
dc.date.available2017-05-08T23:18:39Z
dc.date.copyrightMay, 1984
dc.date.issued1984
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28236#201_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/98897
dc.description.abstractThis paper presents the results of a research program conducted to evaluate the behavior of stress corrosion cracks in sensitized austenitic piping exposed to high temperature, high purity oxygenated water. The program was directed toward the development of a predictive method which included a design margin assessment and an evaluation of crack growth leading to a predictive model. As part of the margin assessment, the program developed diagrams which predicted net section collapse as a function of crack size. Acceptance flaw sizes were then determined by applying a safety factor on the net section collapse condition. The growth behavior of stress corrosion cracks was assessed using laboratory test crack growth rate data coupled with linear elastic fracture mechanics. Knowing the initial flaw size, the crack growth rate data can be used to predict the final flaw size at the end of the next inspection period. Continued operation would be acceptable during this period if the final flaw size is less than the acceptance value. The method developed here can be applied using stress information available in ASME (American Society of Mechanical Engineers) Code piping stress reports and crack growth data presented here. The method developed can be used to establish an in-service inspection plan for power plants with cracked piping allowing continued plant operation. Example predictions for 4-in. (10.16-cm) and 24-in. (61-cm) pipe were made to demonstrate the methodology’s use.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEvaluation of the Growth and Stability of Stress Corrosion Cracks in Sensitized Austenitic Piping
dc.typeJournal Paper
dc.journal.volume106
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264329
dc.journal.fristpage201
dc.journal.lastpage208
dc.identifier.eissn1528-8978
dc.keywordsStability
dc.keywordsStress corrosion cracking
dc.keywordsPipes
dc.keywordsFracture (Materials)
dc.keywordsStress
dc.keywordsCollapse
dc.keywordsIndustrial plants
dc.keywordsWater
dc.keywordsHigh temperature
dc.keywordsIn-service inspection
dc.keywordsPower stations
dc.keywordsASME
dc.keywordsDesign
dc.keywordsFracture mechanics
dc.keywordsInspection AND Safety
dc.treeJournal of Pressure Vessel Technology:;1984:;volume( 106 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record