Show simple item record

dc.contributor.authorJ. M. Bloom
dc.contributor.authorJ. L. Hechmer
dc.date.accessioned2017-05-08T23:18:39Z
dc.date.available2017-05-08T23:18:39Z
dc.date.copyrightMay, 1984
dc.date.issued1984
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28236#196_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/98896
dc.description.abstractThis paper presents a simple procedure for determining the validity limits of linear elastic fracture mechanics (LEFM) calculations for low alloy steel (ferritic) structures. The procedure is limited to structures with flaws whose depths are 50 percent or less of the wall thickness of the component at the flaw location and to components which can be considered to be in a plane strain state. Typical yield and ultimate strengths are assumed to be 60 and 80 ksi (414 and 552 MPa), respectively. The procedure is based upon failure assessment curves derived for typical nuclear vessels and components. Calculations of the ratios of the linear elastic stress intensity factor to the plane strain fracture toughness and the applied load to the plastic collapse load are used in conjunction with these curves to determine the validity limits of LEFM. The procedure is limited to the consideration of primary loading. When the load calculated by LEFM deviates significantly from the load calculated assuming elastic-plastic behavior, LEFM is deemed to be invalid and an elastic-plastic calculation procedure is recommended. Example problems are given which demonstrate the applicability of LEFM analysis in one case and the inapplicability in another case. The paper is an extension of the ideas and work generated from the Electric Power Research Institute research project RP 1237-2.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleLimits of Linear Elastic Fracture Mechanics
dc.typeJournal Paper
dc.journal.volume106
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264328
dc.journal.fristpage196
dc.journal.lastpage200
dc.identifier.eissn1528-8978
dc.keywordsFracture mechanics
dc.keywordsStress
dc.keywordsPlane strain
dc.keywordsVessels
dc.keywordsWall thickness
dc.keywordsElectricity (Physics)
dc.keywordsAlloy steel
dc.keywordsCollapse
dc.keywordsFailure AND Fracture toughness
dc.treeJournal of Pressure Vessel Technology:;1984:;volume( 106 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail
This item appears in the following Collection(s)

Show simple item record