Show simple item record

dc.contributor.authorR. Kumar
dc.date.accessioned2017-05-08T23:18:38Z
dc.date.available2017-05-08T23:18:38Z
dc.date.copyrightAugust, 1984
dc.date.issued1984
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28241#279_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/98884
dc.description.abstractEffects of pipe breaks on nozzle design have been considered in this paper. Simple methods have been used for estimating the maximum possible pipe whip loads for design of nozzles and other components. The required minimum thickness for nozzles has been established to account for pipe whip loads in the design. For typical nozzle and pipe materials, this thickness within reinforcement limit of nozzles should be approximately two and a half (2 1/2) times the attached pipe thickness.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePipe Whip Considerations for Design of Nozzles
dc.typeJournal Paper
dc.journal.volume106
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264344
dc.journal.fristpage279
dc.journal.lastpage282
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;1984:;volume( 106 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record