Show simple item record

dc.contributor.authorF. Ellyin
dc.contributor.authorH.-P. Li
dc.date.accessioned2017-05-08T23:18:38Z
dc.date.available2017-05-08T23:18:38Z
dc.date.copyrightAugust, 1984
dc.date.issued1984
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28241#255_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/98880
dc.description.abstractAn experimental investigation has been carried out on large plates made of pressure vessel steel A516 Gr.70, to determine the fatigue crack growth rate. The specimen size was 914.4 × 304.8 × 12.7 mm (36 × 12 × 0.5 in.) with an initial central through crack of about 92 mm (3.6 in.). The stress ratio, R , applied to the specimens varied from zero to 0.4. This ratio was maintained constant during a test, but the stress amplitude, Δσ, at times was increased in order to obtain data under a large range of stress intensity factor, ΔK . The crack growth rate, da /dN , is expressed in terms of stress intensities, ΔK and K max , through a power-law-type equation. The variation of material constants with the applied stress ratio is discussed. From the data analysis, a general equation for the crack propagation rate is suggested in the form of da /dN = C (K max )n where C and n are functions of ΔK , K max and material parameters. The results are also compared with the recommended ASME Code formula and are found to be in fairly good agreement.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFatigue Crack Growth in Large Specimens With Various Stress Ratios
dc.typeJournal Paper
dc.journal.volume106
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264340
dc.journal.fristpage255
dc.journal.lastpage260
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;1984:;volume( 106 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record