Show simple item record

dc.contributor.authorA. K. Dhalla
dc.date.accessioned2017-05-08T23:18:38Z
dc.date.available2017-05-08T23:18:38Z
dc.date.copyrightAugust, 1984
dc.date.issued1984
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28241#230_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/98876
dc.description.abstractExplicit piping design procedures are not provided in theASME Code for structural evaluation of ovalization and fabrication effects at the butt-welded end of an elbow. This paper presents a conservative semi-analytical procedure that can be used with elastic as well as inelastic analysis to evaluate an elbow cross section welded to a straight pipe. The concept of carry-over factors is used to obtained ovalization stresses or strains at the elbow end. The stresses introduced by material and geometric nonuniformities in the fabrication process are then added to the ovalization stresses to complete structural evaluation of the girth butt-welded elbow joint.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStructural Evaluation of a Butt-Welded Elbow End: A Simplified Procedure
dc.typeJournal Paper
dc.journal.volume106
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264337
dc.journal.fristpage230
dc.journal.lastpage236
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;1984:;volume( 106 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record