Show simple item record

dc.contributor.authorM. E. Karabin
dc.contributor.authorA. K. Dhalla
dc.date.accessioned2017-05-08T23:18:36Z
dc.date.available2017-05-08T23:18:36Z
dc.date.copyrightNovember, 1984
dc.date.issued1984
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28245#323_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/98850
dc.description.abstractThis paper illustrates that in addition to the elastic stress intensity range it is necessary to evaluate the stress intensities (and corresponding material properties) at specific times during a postulated thermal transient to characterize inelastic response at a structural discontinuity. The specific case of an austenitic flued head operating in a temperature range of 600 to 1050°F (316 to 538°C) is used to calculate ratcheting strain accumulation due to cyclic primary and secondary loads. Detailed inelastic analyses were performed to evaluate two designs. Both designs have essentially the same stress intensity range; however, only the design with lower stress intensity during steady-state elevated temperature operation satisfied the ASME Code Case N-47 strain accumulation limits.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleImplication of Elastic Stress Range at Structural Discontinuity
dc.typeJournal Paper
dc.journal.volume106
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264359
dc.journal.fristpage323
dc.journal.lastpage329
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsTemperature
dc.keywordsMaterials properties
dc.keywordsDesign
dc.keywordsInelastic analysis
dc.keywordsSteady state AND ASME Standards
dc.treeJournal of Pressure Vessel Technology:;1984:;volume( 106 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record