Show simple item record

dc.contributor.authorW. Cheng
dc.contributor.authorG. Stevick
dc.contributor.authorI. Finnie
dc.date.accessioned2017-05-08T23:18:08Z
dc.date.available2017-05-08T23:18:08Z
dc.date.copyrightJanuary, 1984
dc.date.issued1984
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26896#21_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/98569
dc.description.abstractIt is assumed that the axial bending stresses which arise from this type of weld have a linear distribution. From these stresses, axisymmetric solutions in the literature enable the stress intensity factor to be calculated for an internal circumferential crack. In this paper it is shown that the same solution may be obtained from the plane strain solution for bending of a cracked beam. This approach applies to any radius to thickness ratio for thin-walled pipe while the axisymmetric solutions apply only for the specific ratios taken in the numerical solutions. Also, the present procedure allows the radial deflection and moment on the crack plane to be determined as a function of crack depth with simple calculations.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePredictions of the Stress Intensity Factor for an Internal Circumferential Crack at a Butt-Weld Between Cylinders Using the Plane Strain Solution
dc.typeJournal Paper
dc.journal.volume106
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225672
dc.journal.fristpage21
dc.journal.lastpage24
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsFracture (Materials)
dc.keywordsCylinders
dc.keywordsPlane strain
dc.keywordsThickness
dc.keywordsDeflection
dc.keywordsBending (Stress) AND Pipes
dc.treeJournal of Engineering Materials and Technology:;1984:;volume( 106 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record