Show simple item record

dc.contributor.authorJ. A. Bailey
dc.contributor.authorM. M. Elkhabeery
dc.date.accessioned2017-05-08T23:18:06Z
dc.date.available2017-05-08T23:18:06Z
dc.date.copyrightApril, 1984
dc.date.issued1984
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26898#161_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/98554
dc.description.abstractThe effects of cutting speed, chip-tool contact length, and tool surface finish on the surface integrity of solution-treated and aged 2024-aluminum alloy, that is machined under lubricated orthogonal conditions are investigated. The surface region of machined workpieces is examined using a variety of diagnostic techniques. In addition, tool forces are measured and the cutting geometry is determined. The results show that a variety of geometrical surface features are generated that contribute to the natural surface roughness, and that a plastically deformed surface region is generated that contains variations in hardness, microstructure, and residual plastic strain. The results are interpreted in terms of the type of chip produced, the mechanics and thermodynamics of the cutting process and the lubricating action of cutting fluids. When the results of the investigation are compared with similar results derived under nonlubricated conditions, it is found that at low cutting speeds application of a lubricant produces a reduction in tool forces, power consumption, surface roughness, surface defects, and subsurface deformation, whereas at high cutting speeds application of a lubricant has little influence on the cutting process.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSurface Integrity in Machining Solution-Treated and Aged 2024-Aluminum Alloy, Using Natural and Controlled Contact Length Tools. Part II—Lubricated Conditions
dc.typeJournal Paper
dc.journal.volume106
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225693
dc.journal.fristpage161
dc.journal.lastpage166
dc.identifier.eissn1528-8889
dc.keywordsAluminum
dc.keywordsMachining
dc.keywordsAlloys
dc.keywordsEquipment and tools
dc.keywordsCutting
dc.keywordsLubricants
dc.keywordsSurface roughness
dc.keywordsForce
dc.keywordsDeformation
dc.keywordsThermodynamics
dc.keywordsFluids
dc.keywordsProduct quality
dc.keywordsFinishes
dc.keywordsEnergy consumption AND Geometry
dc.treeJournal of Engineering Materials and Technology:;1984:;volume( 106 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record