Show simple item record

dc.contributor.authorM. M. Elkhabeery
dc.contributor.authorJohn A. Bailey
dc.date.accessioned2017-05-08T23:18:06Z
dc.date.available2017-05-08T23:18:06Z
dc.date.copyrightApril, 1984
dc.date.issued1984
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26898#152_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/98553
dc.description.abstractThe effects of cutting speed, chip-tool contact length and tool surface finish on the surface integrity of a solution-treated and aged 2024-Aluminum alloy, that is machined under dry, orthogonal conditions are investigated. The surface region of machined workpieces is examined using a wide variety of diagnostic techniques. In addition, tool forces are measured and both the cutting geometry and cutting temperatures are calculated. The results of the investigation show that a wide variety of geometrical surface features are generated that contribute to the natural surface roughness. The results also show that a plastically deformed surface region is generated that contains variations in hardness, microstructure and residual strain. The results of the investigation are interpreted in terms of the type of chip produced, formation of the built-up edge, the mechanics and thermodynamics of the cutting process and the interaction between the tool nose region and freshly machined workpiece surface.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSurface Integrity in Machining Solution-Treated and Aged 2024-Aluminum Alloy, Using Natural and Controlled Contact Length Tools. Part I—Unlubricated Conditions
dc.typeJournal Paper
dc.journal.volume106
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225691
dc.journal.fristpage152
dc.journal.lastpage160
dc.identifier.eissn1528-8889
dc.keywordsAluminum
dc.keywordsMachining
dc.keywordsAlloys
dc.keywordsEquipment and tools
dc.keywordsCutting
dc.keywordsGeometry
dc.keywordsForce
dc.keywordsThermodynamics
dc.keywordsTemperature
dc.keywordsSurface roughness AND Finishes
dc.treeJournal of Engineering Materials and Technology:;1984:;volume( 106 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record