Show simple item record

dc.contributor.authorE. Krempl
dc.contributor.authorH. Lu
dc.date.accessioned2017-05-08T23:18:02Z
dc.date.available2017-05-08T23:18:02Z
dc.date.copyrightOctober, 1984
dc.date.issued1984
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26900#376_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/98522
dc.description.abstractThin-walled tubes were subjected to fully reversed strain-controlled axial (A), torsional (T), in-phase (I) and out-of-phase (O) loading. A computer controlled MTS axial-torsion servocontrolled testing machine and strain measurement on the uniform section of the specimen were used in all tests. Each of four specimens was subjected to combinations of A, T, and I segments, of two hundred cycles each, followed by an O-segment. In between every segment, axial, and torsional check-tests were performed to obtain information on hardening and rate dependence. During cycling the normalized stress amplitude was observed to increase nearly threefold. Even if cyclic saturation was reached during a segment, a change in loading direction caused further hardening followed by subsequent softening which rapidly subsided. Only the O-segment showed hardening exclusively. After the A, T, and I segments, a “cross-effect” was observed which disappeared after the final O-segment. Compared to the considerable hardening, rate dependence as measured by relaxation and strain-rate change tests varied little during cycling.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Hardening and Rate-Dependent Behavior of Fully Annealed AISI Type 304 Stainless Steel Under Biaxial In-Phase and Out-of-Phase Strain Cycling at Room Temperature
dc.typeJournal Paper
dc.journal.volume106
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225733
dc.journal.fristpage376
dc.journal.lastpage382
dc.identifier.eissn1528-8889
dc.keywordsTemperature
dc.keywordsHardening
dc.keywordsStainless steel
dc.keywordsStrain measurement
dc.keywordsTorsion
dc.keywordsTesting
dc.keywordsComputers
dc.keywordsCycles
dc.keywordsMachinery
dc.keywordsRelaxation (Physics) AND Stress
dc.treeJournal of Engineering Materials and Technology:;1984:;volume( 106 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record