Show simple item record

dc.contributor.authorD. L. Marriott
dc.date.accessioned2017-05-08T23:16:19Z
dc.date.available2017-05-08T23:16:19Z
dc.date.copyrightMay, 1983
dc.date.issued1983
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28222#179_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/97540
dc.description.abstractThe paper describes a technique for estimating creep deformation from the results of short-term proof tests. The method relies on the concept of a reference stress which is representative of the general stress level in the component. It is shown that the method provides an upper, and therefore safe, bound on creep deformation. Application to a complex piping component is used to illustrate the procedure and some of the practical problems of interpreting the experimental data. Finally, an attempt is made to relate the reference stress method to tentative design procedures in Code Case N.47 of the ASME III Code.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEstimation of Creep Deformation in Components From Short-Term Proof Test Data
dc.typeJournal Paper
dc.journal.volume105
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264261
dc.journal.fristpage179
dc.journal.lastpage184
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;1983:;volume( 105 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record