Show simple item record

dc.contributor.authorH. Terada
dc.date.accessioned2017-05-08T23:16:18Z
dc.date.available2017-05-08T23:16:18Z
dc.date.copyrightMay, 1983
dc.date.issued1983
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28222#132_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/97532
dc.description.abstractTwo-dimensional stress analysis for the standard compact specimen under plane stress and plane strain conditions were carried out by using the boundary collocation method. The Dugdale model concept was employed for elasto-plastic analysis. Plastic zone size and crack opening displacements at the typical locations, such as edge of plate, load line, and crack tip, were calculated for the practical range of applied load, and crack length-to-width ratio in the fracture toughness tests. In the process of elasto-plastic analysis, crack opening displacements and stress intensity factors corresponding to the elastic solution of the compact specimen were obtained. These results were shown to reasonably agree with those derived by Srawley and Gross, and by Newman.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleElasto-Plastic Stress Analysis of the Standard Compact Specimen
dc.typeJournal Paper
dc.journal.volume105
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264254
dc.journal.fristpage132
dc.journal.lastpage137
dc.identifier.eissn1528-8978
dc.treeJournal of Pressure Vessel Technology:;1983:;volume( 105 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record