Show simple item record

dc.contributor.authorW. E. Baker
dc.contributor.authorJ. G. Bennett
dc.contributor.authorC. D. Babcock
dc.date.accessioned2017-05-08T23:16:15Z
dc.date.available2017-05-08T23:16:15Z
dc.date.copyrightNovember, 1983
dc.date.issued1983
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28228#342_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/97505
dc.description.abstractSix steel shells having nuclear containmentlike features were fabricated and loaded to failure with an offset axial load. The shells (R /t = 500) buckled plastically. Four of the shells had reinforced circular cutouts. These penetrations were sized to cut no ring-stiffener, a single, two- or three-ring stiffeners. Reinforcing and framing around the penetrations were based upon the area-replacement rule of the applicable portion of the ASME Boiler and Pressure Vessel Code and were of a design to simulate actual practice for nuclear steel containments. Prior to testing, imperfections were measured and strain gages were applied to determine information on load distribution at the ends of the cylinder and strain fields at areas likely to buckle. Buckling loads were determined for an axial load applied with an eccentricity of R /2 where R is the cylinder radius. The results showed that the buckling load and mode for the shell having a penetration that did not cut a ring stiffener were essentially the same as those for the unpenetrated shell. The buckling loads for the penetrated shells in which stiffeners were interrupted were less than that for the unpenetrated shells. Results of all tests are compared to numerical solutions carried out using a nonlinear collapse analysis and to the predictions of ASME Code Case N-284.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Buckling Investigation of Ring-Stiffened Cylindrical Shells Under Unsymmetrical Axial Loads
dc.typeJournal Paper
dc.journal.volume105
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264291
dc.journal.fristpage342
dc.journal.lastpage346
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsPipes
dc.keywordsBuckling
dc.keywordsShells
dc.keywordsSteel
dc.keywordsCylinders
dc.keywordsFailure
dc.keywordsCollapse
dc.keywordsTesting
dc.keywordsASME Boiler and Pressure Vessel Code
dc.keywordsStructural frames
dc.keywordsDesign
dc.keywordsStrain gages AND ASME Standards
dc.treeJournal of Pressure Vessel Technology:;1983:;volume( 105 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record