Show simple item record

dc.contributor.authorA. M. Ermi
dc.contributor.authorJ. Moteff
dc.date.accessioned2017-05-08T23:15:42Z
dc.date.available2017-05-08T23:15:42Z
dc.date.copyrightJanuary, 1983
dc.date.issued1983
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26890#21_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/97204
dc.description.abstractTransmission and scanning electron microscopy were used to study the substructural development, crack initiation and crack propagation of AISI 304 stainless steel tested in low-cycle fatigue with various hold times. Tests at 593°C, a strain rate of 4 E-03 s−1 and strain ranges of 0.5, 1.0 and 2.0 percent were interrupted at various fractions of the fatigue life, both during rapid hardening and during saturation. Cells developed during the first few percent of the fatigue life, depending on a threshold stress value, below which cells were not observed. The cell size had a different dependence on the relaxed tensile stress during rapid hardening than during saturation. A work-hardening model relating the peak saturation stress to strain and cell size also applied during the late stages of rapid hardening. The number of cycles to initiate a crack of one grain diameter and to propagate the crack to failure were proportionally reduced for one minute tension holds. For a 60 minute tension hold, crack propagation occupied a much smaller fraction of the fatigue life.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMicrostructural Development and Cracking Behavior of AISI 304 Stainless Steel Tested in Time Dependent Fatigue Modes
dc.typeJournal Paper
dc.journal.volume105
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225614
dc.journal.fristpage21
dc.journal.lastpage30
dc.identifier.eissn1528-8889
dc.keywordsFatigue
dc.keywordsFracture (Process)
dc.keywordsStainless steel
dc.keywordsTension
dc.keywordsFatigue life
dc.keywordsHardening
dc.keywordsFracture (Materials)
dc.keywordsStress
dc.keywordsCrack propagation
dc.keywordsCycles
dc.keywordsFailure
dc.keywordsScanning electron microscopy
dc.keywordsLow cycle fatigue AND Work hardening
dc.treeJournal of Engineering Materials and Technology:;1983:;volume( 105 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record