Show simple item record

dc.contributor.authorK. Tokaji
dc.contributor.authorZ. Ando
dc.contributor.authorT. Imai
dc.contributor.authorT. Kojima
dc.date.accessioned2017-05-08T23:15:41Z
dc.date.available2017-05-08T23:15:41Z
dc.date.copyrightApril, 1983
dc.date.issued1983
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26892#88_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/97189
dc.description.abstractA high strength steel was studied in 3 percent saltwater to investigate the effects of a corrosive environment and sheet thickness on fatigue crack propagation behavior following the application of a single tensile overload. Experiments were carried out under sinusoidally varying loads at a load ratio of 0 and frequency of 10 Hz. A single tensile overload was found to cause delayed retardation, and the crack propagation rate at first increased, followed by fairly rapid decrease to a minimum value and then increased gradually to its steady-state value, just as it did in air. The overload affected zone size and the retardation cycles increased with decreasing sheet thickness, just as they did in air. However, the zone size and the cycles were larger in 3 percent saltwater than in air. Since the crack propagation rates through the overload affected zone were not affected by the test environment, the longer retardation cycles in 3 percent saltwater were attributed to an enlargement of the overload affected zone size. The crack propagation behavior following the application of a single tensile overload in 3 percent saltwater was well explained by the crack closure concept.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFatigue Crack Retardation of High Strength Steel in Saltwater
dc.typeJournal Paper
dc.journal.volume105
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225631
dc.journal.fristpage88
dc.journal.lastpage92
dc.identifier.eissn1528-8889
dc.keywordsHigh strength steel
dc.keywordsFatigue cracks
dc.keywordsCrack propagation
dc.keywordsCycles
dc.keywordsStress
dc.keywordsThickness
dc.keywordsSteady state AND Fracture (Materials)
dc.treeJournal of Engineering Materials and Technology:;1983:;volume( 105 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record