Show simple item record

dc.contributor.authorW. N. Findley
dc.contributor.authorR. M. Reed
dc.date.accessioned2017-05-08T23:15:40Z
dc.date.available2017-05-08T23:15:40Z
dc.date.copyrightJuly, 1983
dc.date.issued1983
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26893#195_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/97178
dc.description.abstractResults of fatigue tests are presented for thick tubes of 32.3 mm (1.27 in) ID and wall ratio of 2.5 of SAE 4333 steel. Tubes having both as-received and honed bores were autofrettaged to three different degrees. Results are given for both open-ended and closed-ended autofrettage. Autofrettage increased the fatigue strength as much as 107 percent. Over autofrettage and open-ended autofrettage produced results not much different from closed-ended normal autofrettage. Under autofrettage causing half the change in diameter of normal autofrettage produced 21 percent less fatigue strength than normal autofrettage.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFatigue of Autofrettaged Thick Tubes: Closed and Open Ended; As-Received and Honed
dc.typeJournal Paper
dc.journal.volume105
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225643
dc.journal.fristpage195
dc.journal.lastpage201
dc.identifier.eissn1528-8889
dc.keywordsFatigue
dc.keywordsSteel
dc.keywordsFatigue strength
dc.keywordsFatigue testing AND Autofrettage
dc.treeJournal of Engineering Materials and Technology:;1983:;volume( 105 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record