Show simple item record

dc.contributor.authorS. L. Collier
dc.contributor.authorC. C. Hoerner
dc.contributor.authorC. E. Davila
dc.date.accessioned2017-05-08T23:15:20Z
dc.date.available2017-05-08T23:15:20Z
dc.date.copyrightMarch, 1983
dc.date.issued1983
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26389#58_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/96991
dc.description.abstractSince check valves are often installed and forgotten, some guidance is needed for their installation so that maintenance can be minimized and scheduled. A study of their behavior over a wide range of flows when installed at various spacing from disturbances (elbow, swedges, pump discharge) was undertaken. Film taken through transparent pipes showed the action to be erratic. In order to obtain relative quantitative data, a large number of tests were run in which the wear was accelerated greatly by the use of very soft parts. These results are presented in a number of graphs. Operating behavior is compared to certain of the accelerated tests for comparison purposes, showing that the results offer reasonable guidance for planning and installing valves of this general type to minimize maintenance by good installation practices.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleBehavior and Wear of Check Valves
dc.typeJournal Paper
dc.journal.volume105
dc.journal.issue1
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.3230877
dc.journal.fristpage58
dc.journal.lastpage61
dc.identifier.eissn1528-8994
dc.keywordsWear
dc.keywordsValves
dc.keywordsMaintenance
dc.keywordsPipes
dc.keywordsPumps
dc.keywordsTransparency AND Flow (Dynamics)
dc.treeJournal of Energy Resources Technology:;1983:;volume( 105 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record