Show simple item record

dc.contributor.authorG. C. Feng
dc.contributor.authorP. W. Schumacher
dc.date.accessioned2017-05-08T23:15:17Z
dc.date.available2017-05-08T23:15:17Z
dc.date.copyrightJune, 1983
dc.date.issued1983
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26390#138_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/96958
dc.description.abstractThe finite element method was used to analyze the stresses in a rock bit cutter tooth under applied loads. Detailed finite element models were constructed to allow accurate descriptions of the structural material properties of a tooth design which includes carburization and hardmetal application. Numerical solutions were obtained for investigating stress concentrations and plastic region growths in a cutter tooth when loaded beyond its yield point. It was found that the finite element method can be a powerful tool for improving the performance of a cutter tooth. Design objectives can be achieved through parameteric studies of stress level variations against geometry and material property changes on a computer system.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleRock Bit Cutter Tooth Design and Analysis
dc.typeJournal Paper
dc.journal.volume105
dc.journal.issue2
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.3230893
dc.journal.fristpage138
dc.journal.lastpage144
dc.identifier.eissn1528-8994
dc.keywordsDesign
dc.keywordsRocks
dc.keywordsStress
dc.keywordsFinite element methods
dc.keywordsMaterials properties
dc.keywordsCarburization
dc.keywordsYield point
dc.keywordsComputers
dc.keywordsFinite element model AND Geometry
dc.treeJournal of Energy Resources Technology:;1983:;volume( 105 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record