Show simple item record

dc.contributor.authorG. A. Okpobiri
dc.contributor.authorC. U. Ikoku
dc.date.accessioned2017-05-08T23:15:14Z
dc.date.available2017-05-08T23:15:14Z
dc.date.copyrightDecember, 1983
dc.date.issued1983
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26395#542_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/96915
dc.description.abstractThis work covers both theoretical and experimental analysis of frictional losses due to the presence of solids in vertical flow of solids-foam slurries. Rabinowitsh-Mooney generalized flow equations for time-independent fluids from the theoretical basis for the rheological analysis. Experimental work was done with an apparatus designed to simulate actual field conditions as closely as possible. The test section consists of an annulus with 4.0-in. casing and 1.5-in. tubing. The surface active agent used is an aniomic biodegradable foamer (ADOFOAM BF-1) and constitutes 1 percent of the liquid volume. Foam qualities and wall shear rates ranged from 0.64 to 0.99, and 100 to 1000 sec−1 , respectively. Semi-empirical equations for predicting friction factors due to solids are presented. Sandstone and limestone particles were used. Average particle size ranged from 0.025 to 0.11 in. and a total of 337 data points were used in the correlations. Data collection was carried out above solid saltation velocities under fully developed steady-state flow conditions. Results show that the friction factor of suspension can be treated as the sum of the friction factor due to the fluid and that due to the solids. For a constant foam Reynold’s number, the frictional losses due to the presence of solids increase as the solids mass flow rate (or solids content) increases. Solids friction factor was found to increase with increasing particles Froude number (gds /VF 2 ) , density ratio (ρs /ρF ), solids concentration, but decreases with increasing fluid Reynolds’ number.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Determination of Friction Factors for Mist and Foam Drilling and Well Cleanout Operations
dc.typeJournal Paper
dc.journal.volume105
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.3230968
dc.journal.fristpage542
dc.journal.lastpage553
dc.identifier.eissn1528-8994
dc.keywordsFriction
dc.keywordsDrilling
dc.keywordsSolids
dc.keywordsFlow (Dynamics)
dc.keywordsFluids
dc.keywordsParticulate matter
dc.keywordsEquations
dc.keywordsExperimental analysis
dc.keywordsParticle size
dc.keywordsSteady state
dc.keywordsData collection
dc.keywordsReynolds number
dc.keywordsDensity
dc.keywordsTubing
dc.keywordsShear (Mechanics)
dc.keywordsSlurries AND Annulus
dc.treeJournal of Energy Resources Technology:;1983:;volume( 105 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record