Show simple item record

dc.contributor.authorF. V. Ellis
dc.contributor.authorS. O. Hilton
dc.contributor.authorJ. F. Henry
dc.contributor.authorJ. E. Bynum
dc.date.accessioned2017-05-08T23:14:10Z
dc.date.available2017-05-08T23:14:10Z
dc.date.copyrightMay, 1982
dc.date.issued1982
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28209#120_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/96320
dc.description.abstractAn investigation was performed on a circumferential weld joint in a 1/2 Cr-1/2 Mo-1/4 V high-pressure steam inlet pipe following the detection of steam leakage in a weld area. The component, 326 mm o.d. × 55 mm wall steam pipe, had accumulated approximately 75,000 hr of service at 566C. A special welding technique had been employed with the 2-1/4 Cr-1 Mo weld metal which created a fully refined heat-affected zone (HAZ) grain structure. The failure path conformed to the contour of the HAZ through more than half of the wall thickness. The cracking was intergranular and had propagated in a narrow zone of material at the intersection of the fine-grained HAZ and the parent metal. For the base metal, the short-time rupture strengths of the service-exposed material were below those of the unexposed material. A Larson-Miller parameter correlation indicated that the nominal operating stress and temperature are in the regime where the rupture strengths for the service-exposed base material are as good as those for unexposed material.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleInfluence of Service Exposure on Base and Weld Metal of 1/2 Cr-1/2 Mo-1/4 V High-Pressure Steam Inlet Piping
dc.typeJournal Paper
dc.journal.volume104
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264187
dc.journal.fristpage120
dc.journal.lastpage129
dc.identifier.eissn1528-8978
dc.keywordsMetals
dc.keywordsHigh pressure (Physics)
dc.keywordsPipes
dc.keywordsSteam
dc.keywordsRupture
dc.keywordsWall thickness
dc.keywordsLeakage
dc.keywordsFailure
dc.keywordsIntersections
dc.keywordsFracture (Process)
dc.keywordsHeat
dc.keywordsTemperature
dc.keywordsWelding
dc.keywordsStress AND Base metals
dc.treeJournal of Pressure Vessel Technology:;1982:;volume( 104 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record