Show simple item record

dc.contributor.authorJ. R. Shadley
dc.contributor.authorN. Merah
dc.contributor.authorE. F. Rybicki
dc.date.accessioned2017-05-08T23:14:08Z
dc.date.available2017-05-08T23:14:08Z
dc.date.copyrightAugust, 1982
dc.date.issued1982
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28211#193_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/96302
dc.description.abstractOne method for reducing stress corrosion cracking problems called induction Heating for Stress Improvement (IHSI) has been successful in producing compressive residual stresses on the inside surface of welded pipes. During the time that the induction heating coil is turned on, however, the process causes tensile stresses at the inner wall, raising questions about the effect that the induced tensile stress field may have on existing flaws in the pipe. To provide a basis for comparing as-welded stress distributions with the stress distributions occurring during the IHSI process, stress intensity factors were computed for part-through, axisymmetric, circumferential cracks in pipes using linear elastic fracture mechanics analyses. Results for as-welded stress distributions agree with the field experience that most of the crack pipes in Boiling Water Reactor piping systems are smaller diameter pipes in the 4–12-in. (102–305-mm) range. Stress intensity factors in the smaller diameter pipes for the stresses during IHSI were comparable to those for the as-welded stresses. For the 26-in- (660-mm-) dia pipe, the large changes in the stress distributions during the IHSI process suggest the possibility of a net closing or opening of a flaw existing in the pipe prior to the heat treatment.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Effect of Induction Heating Stress Remedies on Existing Flaws in Pipes
dc.typeJournal Paper
dc.journal.volume104
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264203
dc.journal.fristpage193
dc.journal.lastpage197
dc.identifier.eissn1528-8978
dc.keywordsElectromagnetic induction
dc.keywordsStress
dc.keywordsPipes
dc.keywordsHeating
dc.keywordsTension
dc.keywordsFracture (Materials)
dc.keywordsFracture mechanics
dc.keywordsBoiling water reactors
dc.keywordsPiping systems
dc.keywordsHeat treating (Metalworking)
dc.keywordsResidual stresses AND Stress corrosion cracking
dc.treeJournal of Pressure Vessel Technology:;1982:;volume( 104 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record