Show simple item record

dc.contributor.authorH. G. deLorenzi
dc.date.accessioned2017-05-08T23:14:06Z
dc.date.available2017-05-08T23:14:06Z
dc.date.copyrightNovember, 1982
dc.date.issued1982
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28215#278_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/96282
dc.description.abstractA maximum postulated surface flaw in the beltline region of a PWR pressure vessel has been analyzed under elastic-plastic conditions. The analysis was performed using 3-D finite element methods, and the deformation theory of plasticity was used to describe the plastic flow of the material. The calculations were carried out for the internal pressure varying from the design pressure up to approximately twice the design pressure. The results show that at the design pressure the plastic flow of the material around the crack front is so small that an elastic analysis is adequate. However, the commonly used approach of treating the flaw in the vessel as a surface flaw in a flat plate under far field tension loading is nonconservative. At a pressure of approximately 50 percent over the design pressure the energy release rate derived from an elastic analysis starts to deviate from the value obtained from an elastic-plastic calculation. The elastic result now starts to be nonconservative and at twice the design pressure the elastic analysis will clearly underestimate the severity of the crack. A 2-D elastic-plastic plane strain approximation will on the other hand grossly overestimate the severity of the crack. A realistic 3-D elastic-plastic analysis is, therefore, needed to estimate the safety factors of surface flaws and to serve as benchmarks for the development of simpler design calculations.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleElastic-Plastic Analysis of the Maximum Postulated Flaw in the Beltline Region of a Reactor Vessel
dc.typeJournal Paper
dc.journal.volume104
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264218
dc.journal.fristpage278
dc.journal.lastpage286
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsPlasticity
dc.keywordsDeformation
dc.keywordsSafety
dc.keywordsPressure vessels
dc.keywordsFinite element methods
dc.keywordsFracture (Materials)
dc.keywordsDesign
dc.keywordsApproximation
dc.keywordsFlat plates
dc.keywordsPlane strain
dc.keywordsTension
dc.keywordsVessels
dc.keywordsElastic analysis
dc.keywordsReactor vessels AND Pressurized water reactors
dc.treeJournal of Pressure Vessel Technology:;1982:;volume( 104 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record