Show simple item record

dc.contributor.authorS. E. Moore
dc.contributor.authorE. C. Rodabaugh
dc.date.accessioned2017-05-08T23:14:06Z
dc.date.available2017-05-08T23:14:06Z
dc.date.copyrightNovember, 1982
dc.date.issued1982
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28215#351_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/96275
dc.description.abstractSection III of the ASME Boiler and Pressure Vessel Code contains simplified design formulas for placing bounds on the plastic deformations in nuclear power plant piping systems. For Class 1 piping a simple equation is given in terms of primary load stress indices (B 1 and B 2 ) and nominal pressure and bending stresses. The B 1 and B 2 stress indices reflect the capacities of various piping products to carry load without gross plastic deformation. In this paper, the significance of the indices, nominal stresses, and limits given in the Code for Class 1 piping and corresponding requirements for Class 2 and Class 3 piping are discussed. Motivation behind recent (1978–1981) changes in the indices and in the associated stress limits is presented.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleBackground for Changes in the 1981 Edition of the ASME Nuclear Power Plant Components Code for Controlling Primary Loads in Piping Systems
dc.typeJournal Paper
dc.journal.volume104
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264228
dc.journal.fristpage351
dc.journal.lastpage361
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsNuclear power stations
dc.keywordsPiping systems
dc.keywordsPipes
dc.keywordsDeformation
dc.keywordsPressure
dc.keywordsBending (Stress)
dc.keywordsDesign
dc.keywordsASME Boiler and Pressure Vessel Code
dc.keywordsEquations AND Formulas
dc.treeJournal of Pressure Vessel Technology:;1982:;volume( 104 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record