Show simple item record

dc.contributor.authorC. E. Jaske
dc.contributor.authorN. D. Frey
dc.date.accessioned2017-05-08T23:13:28Z
dc.date.available2017-05-08T23:13:28Z
dc.date.copyrightApril, 1982
dc.date.issued1982
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26887#137_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/95896
dc.description.abstractSome energy-system structural components may be subjected to 107 or more cycles of small-amplitude, strain-controlled vibrations. In such cases, information on the elevated-temperature, long-life (>106 cycles to failure) fatigue resistance of the austenitic steels often used in these components is needed. Present design guidelines provide fatigue curves for these steels only up to 106 cycles to failure. The objective of the present study was to evaluate the long-life fatigue resistance of one such steel, namely Type 316 stainless steel. Strain-controlled long-life (> 106 cycles to failure) fatigue experiments were conducted on solution-annealed Type 316 stainless steel in air at temperatures from 21 to 593° C. These were all for continuous cycling of smooth specimens under fully reversed straining (no mean stress). Results of this work provided a major advance in understanding the fatigue behavior of this steel. Tentative best-fit fatigue curves have been developed, but more data are needed to establish needed statistical confidence in them. At 21°C, strain and load-controlled experiments gave similar fatigue-resistance values at 108 cycles when inelastic straining was taken into account. However, at 427°C and above, strain-controlled cycling yielded fatigue-resistance levels at 108 cycles about 15 to 25 percent above those for load-controlled cycling. This difference is related to the continually increasing stress levels observed under strain cycling at the higher temperatures. That is, cyclic hardening continues to occur for 105 or more cycles of straining with accompanying two- to threefold increases in strength. This increased strength gives the increased fatigue resistance at long lives. Under load-controlled conditions, such cyclic hardening cannot occur, and the fatigue resistance is lower. Results of this work emphasize the need for considering the intended service conditions in carrying out laboratory experiments. The impact of these results on recommended experimental procedures for long-life fatigue testing of such alloys is discussed. Finally, considerations for application of these data in fatigue design are addressed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleLong-Life Fatigue of Type 316 Stainless Steel at Temperatures up to 593°C
dc.typeJournal Paper
dc.journal.volume104
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225048
dc.journal.fristpage137
dc.journal.lastpage144
dc.identifier.eissn1528-8889
dc.keywordsFatigue
dc.keywordsTemperature
dc.keywordsStainless steel
dc.keywordsCycles
dc.keywordsElectrical resistance
dc.keywordsStress
dc.keywordsSteel
dc.keywordsFailure
dc.keywordsHardening
dc.keywordsDesign
dc.keywordsVibration
dc.keywordsFatigue design
dc.keywordsFatigue testing AND Alloys
dc.treeJournal of Engineering Materials and Technology:;1982:;volume( 104 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record