Show simple item record

dc.contributor.authorJ. L. Hau-Bracamonte
dc.contributor.authorJ. Wallbank
dc.contributor.authorM. L. H. Wise
dc.date.accessioned2017-05-08T23:13:27Z
dc.date.available2017-05-08T23:13:27Z
dc.date.copyrightApril, 1982
dc.date.issued1982
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26887#69_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/95886
dc.description.abstractThe effect of subcritical quenching and room temperature aging on the cutting behavior of mild steel has been studied by optical and electron microscopy. Carbon and nitrogen in supersaturated solid solution and/or as submicroscopic precipitates greatly increase the dynamic strength of the steel and, hence, reduce the rate of metal removal when machining with high speed steel tools. When compared with a steel with a carbon and nitrogen-depleted or precipitation-free ferrite matrix, it is clear that the effect is caused by an increase in the high-strain work-hardening rate and a reduction in dynamic recovery. Because these submicroscopical precipitates are redissolved upon straining, variation of particle size and spacing has little effect upon the rate of metal removal, hence there are no significant differences between the machining behaviour of the steel in the solution heat treated, quench-aged and overaged condition. Transmission and scanning electron microscopy were used to examine the high-strain deformation structure of chips. Subzero cutting, at liquid nitrogen temperature, was used to control the temperature in the primary shear zone and to “freeze” pre-existing structure in the flow-zone.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Plastic Deformation of Mild Steel in Metal Cutting
dc.typeJournal Paper
dc.journal.volume104
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225055
dc.journal.fristpage69
dc.journal.lastpage78
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsSteel
dc.keywordsMetal cutting
dc.keywordsMachining
dc.keywordsNitrogen
dc.keywordsTemperature
dc.keywordsCutting
dc.keywordsCarbon
dc.keywordsEquipment and tools
dc.keywordsScanning electron microscopy
dc.keywordsParticle size
dc.keywordsPrecipitation
dc.keywordsSolid solutions
dc.keywordsWork hardening
dc.keywordsFlow (Dynamics)
dc.keywordsHeat
dc.keywordsElectron microscopy
dc.keywordsTool steel
dc.keywordsFerrites (Magnetic materials)
dc.keywordsShear (Mechanics) AND Quenching (Metalworking)
dc.treeJournal of Engineering Materials and Technology:;1982:;volume( 104 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record