Show simple item record

dc.contributor.authorE. Smith
dc.date.accessioned2017-05-08T23:13:25Z
dc.date.available2017-05-08T23:13:25Z
dc.date.copyrightJuly, 1982
dc.date.issued1982
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26888#215_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/95877
dc.description.abstractZahoor and Kanninen have recently developed a simple procedure for estimating the magnitude of the J-integral for through-wall cracks in pipes subjected to bending loads. This paper gives consideration to their procedure, but to check its predictions against available numerical results, it is explored in detail for the case of a crack in a solid deforming under plane-strain bending conditions. In this case, an implicit assumption in the procedure is that the plastic rotation depends on the ligament size, and not on any other geometrical dimension. This assumption is strictly valid only for deep cracks, and this paper shows the degree of inaccuracy obtained when it is applied to shallow cracks. The assumption is also shown to correlate with the existence of a unique relation, independent of geometrical parameters, between the ligament net-section stress and the J-integral, and also with the existence of Turner’s plastic η factors.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Comparison of J Estimating Procedures for a Solid Subjected to Bending Loads
dc.typeJournal Paper
dc.journal.volume104
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225067
dc.journal.fristpage215
dc.journal.lastpage219
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsFracture (Materials)
dc.keywordsPipes
dc.keywordsPlane strain
dc.keywordsRotation AND Dimensions
dc.treeJournal of Engineering Materials and Technology:;1982:;volume( 104 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record