Show simple item record

dc.contributor.authorR. A. Mayville
dc.contributor.authorI. Finnie
dc.date.accessioned2017-05-08T23:13:25Z
dc.date.available2017-05-08T23:13:25Z
dc.date.copyrightJuly, 1982
dc.date.issued1982
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26888#200_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/95875
dc.description.abstractFracture of beryllium under biaxial states of stress has been studied in the past using thin-walled tubes loaded by combinations of axial load, torsion, and internal pressure. In the present investigation to obtain a triaxial state of stress, notched beams of beryllium with varying dimensions were tested in plane strain four-point bending. The conditions necessary to ensure plane strain are discussed in detail and plane strain finite element analyses are used to determine the stresses and strains at fracture in the notched specimens. Based on the test results a strain dependent, maximum tensile stress fracture criterion is proposed for parts without macroscopic cracks. In addition, the plane strain fracture toughness of beryllium is estimated from the notched bar tests using the RKR model.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Use of Notched Beams to Establish a Multiaxial Stress-Fracture Criterion for Beryllium
dc.typeJournal Paper
dc.journal.volume104
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225065
dc.journal.fristpage200
dc.journal.lastpage206
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsFracture (Process)
dc.keywordsPlane strain
dc.keywordsTension
dc.keywordsFracture toughness
dc.keywordsTorsion
dc.keywordsFinite element analysis
dc.keywordsPressure AND Dimensions
dc.treeJournal of Engineering Materials and Technology:;1982:;volume( 104 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record