Show simple item record

dc.contributor.authorT. T. Shih
dc.contributor.authorJ. K. Donald
dc.date.accessioned2017-05-08T23:11:15Z
dc.date.available2017-05-08T23:11:15Z
dc.date.copyrightApril, 1981
dc.date.issued1981
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26881#104_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/94625
dc.description.abstractAn automated, computer-controlled K-decreasing technique was used to determine the threshold, ΔKth , and low-rate fatigue crack growth of a NiMoV rotor steel. A more conventional K-increasing technique was also used. Excellent agreement between results obtained from both techniques was observed. For the material and environment studied, no crack arrest was observed for crack growth rate down to 2.5 × 10−8 mm/cycle (10−9 in./cycle). As such, an operational definition of ΔKth was defined as the stress intensity factor range corresponding to a crack growth rate of 2.5 × 10−8 mm/cycle (10−9 in./cycle). In room temperature air environment, ΔKth was found to be 6.2 and 4.0 MPam (5.6 and 3.6 ksiin.) for R = 0.1 and R = 0.5, respectively. At the same ΔK level, crack growth rate was found to increase with increasing stress ratio. The influence of stress ratio on crack growth rate, however, decreases with increasing ΔK. By raising temperature to 93° C (200°F), ΔKth was found to be suppressed to 4.4 and 2.9 MPam (4.0 and 2.6 ksiin.) for R = 0.1 and R = 0.5, respectively. Stress ratio effect on crack growth rate is the same as at room temperature, but is less significant. Temperature was found to influence crack growth rate in the threshold region for both stress ratio studied, with higher crack growth rate at 93°C (200°F) than at room temperature. Temperature sensitivity was found to be less for R = 0.5 than R = 0.1. The existence of hydrogen was found to have little effect on ΔKth and low-rate fatigue crack growth behavior of this NiMoV rotor steel.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThreshold and Low-Rate Fatigue Crack Growth of a NiMoV Rotor Steel
dc.typeJournal Paper
dc.journal.volume103
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3224980
dc.journal.fristpage104
dc.journal.lastpage111
dc.identifier.eissn1528-8889
dc.keywordsSteel
dc.keywordsRotors
dc.keywordsFatigue cracks
dc.keywordsFracture (Materials)
dc.keywordsTemperature
dc.keywordsStress
dc.keywordsCycles
dc.keywordsHydrogen AND Computers
dc.treeJournal of Engineering Materials and Technology:;1981:;volume( 103 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record