Show simple item record

dc.contributor.authorL. A. James
dc.date.accessioned2017-05-08T23:11:15Z
dc.date.available2017-05-08T23:11:15Z
dc.date.copyrightJuly, 1981
dc.date.issued1981
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26883#234_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/94614
dc.description.abstractFive different product forms (sheet, plate, bar, forging, and weldments) all taken from the same heat of Alloy 718 were tested at five different temperatures in each of two different heat-treated conditions. In general, no consistent effect of product form was noted for any of the wrought forms (sheet, plate, bar, or forgings). However, the crack growth rates were higher in weldment specimens than in wrought specimens for some test temperature/heat-treatment combinations. The present results suggest that product form did not influence the heat-to-heat variations noted previously in crack growth studies on wrought Alloy 718.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Effect of Product Form Upon Fatigue-Crack Growth Behavior in Alloy 718
dc.typeJournal Paper
dc.journal.volume103
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225007
dc.journal.fristpage234
dc.journal.lastpage239
dc.identifier.eissn1528-8889
dc.keywordsHeat
dc.keywordsTemperature
dc.keywordsAlloys
dc.keywordsForging
dc.keywordsHeat treating (Metalworking)
dc.keywordsForgings (Products)
dc.keywordsFracture (Materials)
dc.keywordsFatigue cracks AND Indium alloys
dc.treeJournal of Engineering Materials and Technology:;1981:;volume( 103 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record