Show simple item record

dc.contributor.authorR. H. Ross
dc.date.accessioned2017-05-08T23:10:52Z
dc.date.available2017-05-08T23:10:52Z
dc.date.copyrightSeptember, 1981
dc.date.issued1981
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26383#190_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/94416
dc.description.abstractThe ASME Boiler and Pressure Vessel Code and publications by many manufacturers caution the design engineer to consider back pressure in discharge piping when sizing and selecting pressure relief valves. Only general guidelines are given, however, because of widely varying installation requirements. This paper addresses manifolded discharge piping system design. The method of analysis provides a simple technique for determining pressure within a discharge piping system. The method is based on adiabatic flow and uses local Mach number to relate expansion of the gas in the pipes to a mass flow function. The paper illustrates that relief valves discharging into lines and headers should not be sized or selected without careful analysis of the entire relief system.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDesign of Discharge Piping for Pressure Relief Systems
dc.typeJournal Paper
dc.journal.volume103
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.3230835
dc.journal.fristpage190
dc.journal.lastpage195
dc.identifier.eissn1528-8994
dc.keywordsPressure
dc.keywordsDesign
dc.keywordsPipes
dc.keywordsRelief valves
dc.keywordsPiping systems
dc.keywordsFlow (Dynamics)
dc.keywordsMach number
dc.keywordsEngineers AND ASME Boiler and Pressure Vessel Code
dc.treeJournal of Energy Resources Technology:;1981:;volume( 103 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record