Show simple item record

dc.contributor.authorR. J. Pick
dc.contributor.authorH. D. Harris
dc.date.accessioned2017-05-08T23:09:47Z
dc.date.available2017-05-08T23:09:47Z
dc.date.copyrightFebruary, 1980
dc.date.issued1980
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28180#84_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/93819
dc.description.abstractThe use of water in high-pressure jet cutting and machining requires seals capable of sealing reciprocating and rotating shafts with minimal leakage. Both Morrison and Parry seals are studied analytically to determine the geometric parameters influencing their behavior in water. Limited experimental evidence supports the findings. In particular, the Morrison seal is most appropriate for use with oil, while the Parry seal shows greater potential for sealing water.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMorrison and Parry Seals for Water Pressures up to 345 MPa
dc.typeJournal Paper
dc.journal.volume102
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3263306
dc.journal.fristpage84
dc.journal.lastpage89
dc.identifier.eissn1528-8978
dc.keywordsWater pressure
dc.keywordsMachining
dc.keywordsSealing (Process)
dc.keywordsHigh pressure (Physics)
dc.keywordsJet cutting
dc.keywordsWater AND Leakage
dc.treeJournal of Pressure Vessel Technology:;1980:;volume( 102 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record