Show simple item record

dc.contributor.authorL. H. Sobel
dc.contributor.authorS. Z. Newman
dc.date.accessioned2017-05-08T23:09:41Z
dc.date.available2017-05-08T23:09:41Z
dc.date.copyrightNovember, 1980
dc.date.issued1980
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28192#400_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/93767
dc.description.abstractPredictions obtained from a simplified finite element analysis are compared with experimental results on the plastic in-plane bending and buckling of a 16-in-dia Type 304 stainless steel piping structure which consists of a 90-deg elbow and two straight tangent pipes. The large displacement analysis is based on the widely used MARC pipe-bend element 17, and on a stress-strain curve obtained from coupon specimens taken from the tested elbow. The simplified analysis predictions are found to be in reasonably good agreement with the experimental results. The analysis underestimates the experimental buckling load by 10 percent and overestimates the deformation at a given load, particularly at the higher load levels.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleComparison of Experimental and Simplified Analytical Results for the In-Plane Plastic Bending and Buckling of an Elbow
dc.typeJournal Paper
dc.journal.volume102
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3263351
dc.journal.fristpage400
dc.journal.lastpage409
dc.identifier.eissn1528-8978
dc.keywordsBuckling
dc.keywordsStress
dc.keywordsPipes
dc.keywordsDeformation
dc.keywordsStress-strain curves
dc.keywordsFinite element analysis
dc.keywordsDisplacement
dc.keywordsStainless steel AND Pipe bends
dc.treeJournal of Pressure Vessel Technology:;1980:;volume( 102 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record