Show simple item record

dc.contributor.authorM. R. Barone
dc.contributor.authorD. A. Caulk
dc.contributor.authorD. C. Chang
dc.date.accessioned2017-05-08T23:06:54Z
dc.date.available2017-05-08T23:06:54Z
dc.date.copyrightJanuary, 1979
dc.date.issued1979
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26867#22_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/92232
dc.description.abstractIn this paper, minimum-weight design of double-layer panels made from sheet molding compound is related to cure time—a critical indicator of manufacturing cost. This is done by incorporating cure time restrictions in the optimization analysis. Depending on the design constraints imposed on the panel, the least-weight design can require cure times which are unacceptably long for economical high volume production. Nevertheless, we show that cure time can be brought within acceptable bounds by design changes that incur only modest increases in weight.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Influence of Cure Time Restrictions on Minimum-Weight Design of Double-Layer SMC Panels
dc.typeJournal Paper
dc.journal.volume101
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443641
dc.journal.fristpage22
dc.journal.lastpage26
dc.identifier.eissn1528-8889
dc.keywordsWeight (Mass)
dc.keywordsSliding mode control AND Design
dc.treeJournal of Engineering Materials and Technology:;1979:;volume( 101 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record