Show simple item record

dc.contributor.authorP. Shahinian
dc.contributor.authorK. Sadananda
dc.date.accessioned2017-05-08T23:06:50Z
dc.date.available2017-05-08T23:06:50Z
dc.date.copyrightJuly, 1979
dc.date.issued1979
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26870#224_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/92194
dc.description.abstractCrack growth rate da/dN in Alloy 718 at 650°C, compared on the conventional ΔK basis, increased with increase in R (Kmin /Kmax ) and also generally with inclusion of hold time at Kmax and Kmin . An exception, however, was that a 1-min hold at a Kmin just below the threshold K for creep crack growth caused retardation of crack growth. Correlation of da/dN for various R levels was better with Kmax than with other parameters such as Kmin , ΔK, and Δ J-integral. Fatigue crack growth in the alloy was found to be time dependent and Kmax controlled under these test conditions and consequently the best overall correlation was given by da/dt with Kmax . An unusual observation was that the addition of hold time to the loading cycle at near zero Kmin (R = 0.05) caused an increase in da/dN, as the result of an environmental interaction.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffects of Stress Ratio and Hold-Time on Fatigue Crack Growth in Alloy 718
dc.typeJournal Paper
dc.journal.volume101
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443681
dc.journal.fristpage224
dc.journal.lastpage230
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsFatigue cracks
dc.keywordsIndium alloys
dc.keywordsFracture (Materials)
dc.keywordsCycles
dc.keywordsCreep AND Alloys
dc.treeJournal of Engineering Materials and Technology:;1979:;volume( 101 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record