Show simple item record

dc.contributor.authorJ. Peck
dc.date.accessioned2017-05-08T23:05:39Z
dc.date.available2017-05-08T23:05:39Z
dc.date.copyrightFebruary, 1978
dc.date.issued1978
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28159#74_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/91518
dc.description.abstractInvestigation shows that there is a preferred cobalt content for a given hardness of a cemented carbide insert when used in a bit which is drilling iron ore. Two parameters determine the hardness of a cemented carbide: cobalt percent and tungsten carbide grain size. By manipulating these two parameters, a number of cemented carbide materials can be made which have the same hardness. Three iron-ore drilling tests have been conducted where test bits contained materials having essentially the same hardness, but where the materials were varied through a range of cobalt content and tungsten carbide grain size. Graphs are presented which depict the effect on fracture resistance of varying the cobalt content-tungsten carbide grain size. In each test, one material showed superior fracture resistance. The test bits drilled iron ores such as hematite or taconite.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleIncreasing the Fracture Resistance of Cemented Carbides During the Drilling of Iron Ores
dc.typeJournal Paper
dc.journal.volume100
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3454437
dc.journal.fristpage74
dc.journal.lastpage76
dc.identifier.eissn1528-8978
dc.keywordsElectrical resistance
dc.keywordsDrilling
dc.keywordsFracture (Process)
dc.keywordsIron
dc.keywordsCobalt
dc.keywordsTungsten AND Grain size
dc.treeJournal of Pressure Vessel Technology:;1978:;volume( 100 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record