• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Bursting Pressure as the Basis for Cylinder Design

    Thumbnail
    View/Open
    JPVTAS-28167#374_1.pdf (798.4Kb)
    Date
    1978
    Author
    W. R. D. Manning
    Metadata
    Show full item record
    Abstract
    This paper gives a brief account of the developments carried out in the Northwich, England, laboratories of Imperial Chemical Industries Limited (ICI) which led to this method of design being used in the first commercial high-pressure polyethylene plant, which went on stream in 1939 at a working pressure of 150 MPa (approximately 22,000 psi). The essential requirement was to determine the lowest value of the bursting pressure, but the difficulty in this is that experimenters tend to get erroneously high values because they raise the pressure too fast. An analytical approach, based on stress/strain relations derived from torsion tests, was therefore developed for comparison. The problems of increasing scale were then resolved by building and operating progressively larger laboratory vessels, leading to those of 10-liter capacity which were used for the polyethylene pilot plant in 1937, operating at pressures up to 200 MPa (approximately 29,000 psi).
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/91465
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV