Show simple item record

dc.contributor.authorR. G. Davies
dc.contributor.authorC. L. Magee
dc.date.accessioned2017-05-08T23:02:57Z
dc.date.available2017-05-08T23:02:57Z
dc.date.copyrightJanuary, 1977
dc.date.issued1977
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26850#47_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/89933
dc.description.abstractThe maximum loads sustainable in both four-point bending and prebent hinge collapse tests of several materials have been determined at crosshead rates from 4.2 × 10−3 mm/s to 4.2 m/s (10−2 –104 in./min). All the materials exhibit a logarithmic dependence of flow stress on crosshead rate; this dependence is consistent with that previously reported for tensile deformation. Although there are some minor differences in the dynamic stress factors obtained by the bending and tensile methods, all the methods rank the materials in the same order. Thus, for materials evaluation the most convenient test method, which is usually the tensile test, can be chosen. For more complex loading geometries than considered here, scale model testing would yield the most reliable results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Effect of Strain Rate Upon the Bending Behavior of Materials
dc.typeJournal Paper
dc.journal.volume99
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443405
dc.journal.fristpage47
dc.journal.lastpage51
dc.identifier.eissn1528-8889
dc.keywordsFlow (Dynamics)
dc.keywordsDeformation
dc.keywordsStress
dc.keywordsHinges
dc.keywordsSustainability
dc.keywordsTesting AND Collapse
dc.treeJournal of Engineering Materials and Technology:;1977:;volume( 099 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record