Show simple item record

dc.contributor.authorN. F. Fiore
dc.contributor.authorD. R. Diercks
dc.date.accessioned2017-05-08T23:02:56Z
dc.date.available2017-05-08T23:02:56Z
dc.date.copyrightJanuary, 1977
dc.date.issued1977
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26850#29_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/89930
dc.description.abstractA series of low-cycle fatigue tests was performed at 593 deg C on Fe-20 Cr-10 Ni and Fe-20 Cr-20 Ni (in weight percent) austenitic alloys in both the cast and wrought conditions. The as-cast alloys exhibited substantially longer cyclic lives than the wrought alloys or wrought Type 304 stainless steel. An effect of Ni content on fatigue life was noted for the cast alloys, but not for the wrought. Striation, measurements indicated that the majority of the cyclic life was spent in crack initiation and early growth in all cases, and the superiority of the cast alloys was almost entirely due to a greater resistance to crack initiation. Macroscopic crack-growth rates were found to be essentially independent of composition and microstructure. A 1-min tension hold time per cycle produced a significant reduction in cyclic life in all cases except for the as-cast high Ni alloy. The decrease in life appeared to be associated with the initiation of cracks from localized deformation at grain boundaries.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMicrostructural Effects in the Low-Cycle Fatigue of Fe-Ni-Cr Austenite
dc.typeJournal Paper
dc.journal.volume99
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443400
dc.journal.fristpage29
dc.journal.lastpage35
dc.identifier.eissn1528-8889
dc.keywordsLow cycle fatigue
dc.keywordsAlloys
dc.keywordsFracture (Materials)
dc.keywordsCycles
dc.keywordsFatigue life
dc.keywordsWeight (Mass)
dc.keywordsDeformation
dc.keywordsMeasurement
dc.keywordsElectrical resistance
dc.keywordsGrain boundaries
dc.keywordsNickel alloys
dc.keywordsStainless steel AND Tension
dc.treeJournal of Engineering Materials and Technology:;1977:;volume( 099 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record