Show simple item record

dc.contributor.authorJ. Wolak
dc.contributor.authorP. Worm
dc.contributor.authorI. Patterson
dc.contributor.authorJ. Bodoia
dc.date.accessioned2017-05-08T23:02:55Z
dc.date.available2017-05-08T23:02:55Z
dc.date.copyrightApril, 1977
dc.date.issued1977
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26852#147_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/89917
dc.description.abstractSilicon carbide particles, mesh 60, were introduced at a known time-rate (wp ) into an air stream flowing at a time-rate (wa ) through a parallel sided nozzle of circular cross-section. Particle velocity (Vz ) within the resulting abrasive jet was measured by means of a specially adapted streaking camera technique. Vz was found to be a function of the nozzle length (L), of the distance (z) from the nozzle exit, of the radial position (r) within the jet, and of the loading ratio (wp /wa ). The results indicate that the parameters Vz , L, z, wa and wp are of primary importance in studies of abrasive erosion as well as in the design and operation of air-powered sandblasting equipment.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleParameters Affecting the Velocity of Particles in an Abrasive Jet
dc.typeJournal Paper
dc.journal.volume99
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443425
dc.journal.fristpage147
dc.journal.lastpage152
dc.identifier.eissn1528-8889
dc.keywordsParticulate matter
dc.keywordsNozzles
dc.keywordsSilicon
dc.keywordsDesign AND Erosion
dc.treeJournal of Engineering Materials and Technology:;1977:;volume( 099 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record