Show simple item record

dc.contributor.authorL. K. Ives
dc.date.accessioned2017-05-08T23:02:55Z
dc.date.available2017-05-08T23:02:55Z
dc.date.copyrightApril, 1977
dc.date.issued1977
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26852#126_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/89913
dc.description.abstractErosion tests were conducted on 310 stainless steel in combustion gas atmospheres at 975°C. SiC particles of 100 mesh (150 μm) size were employed over a velocity range of 15–70 m/s at a 90 deg (perpendicular) angle of impingement. A comparison is made with results obtained at 25°C in air using the same test equipment. Scanning electron microscopy examination of the eroded surfaces revealed important information concerning the nature of the erosion-corrosion process. A multiple component test specimen is described for application in comparing alloys under nearly identical test conditions.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleErosion of 310 Stainless Steel at 975°C in Combustion Gas Atmospheres
dc.typeJournal Paper
dc.journal.volume99
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3443421
dc.journal.fristpage126
dc.journal.lastpage132
dc.identifier.eissn1528-8889
dc.keywordsCombustion gases
dc.keywordsErosion
dc.keywordsStainless steel
dc.keywordsScanning electron microscopy
dc.keywordsTesting equipment
dc.keywordsCorrosion
dc.keywordsAlloys AND Particulate matter
dc.treeJournal of Engineering Materials and Technology:;1977:;volume( 099 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record